AP EAMCET · PHYSICS · Current Electricity

In the given circuit, the potential difference across the plates of the capacitor C in steady state is

A 6.5 V
B 6 V
C 9 V
D 7.5 V

Verified Solution

Answer & Solution

Correct Answer

(A) 6.5 V

Step-by-step Solution

Detailed explanation

NO SOLUTION

Apply the relevant identity from the chapter and substitute the values established in the previous step, keeping the original constraint in view.

Use the simplified expression to isolate the unknown, then plug the result back into the question setup to confirm the working is internally consistent.

Cross-check against a boundary or limiting case. Both the dimensional balance and the qualitative behaviour at the extreme should agree with the candidate answer.

Combine the steps above to identify the correct option. The remaining choices each fail at least one of the consistency, dimensional, or boundary checks.

Same subject

If the given graph shows the load $(\mathrm{W})$ attached to and the elongation $(\Delta l)$ produced in a wire of length one meter and area of cross-section $1 \mathrm{~mm}^2$, then the Young's modulus of the material of the wire is

AP EAMCET 2025 Medium
A car covers a distance at speed of $60 km h^{- 1}$ . It returns and comes back to the original point moving at a speed of $V$ . If the average speed for the round trip is $48 km h^{- 1}$ , then the magnitude of $v$ is

AP EAMCET 2022 Easy
As shown in the figure, a block of mass $9 \mathrm{~kg}$ is hung by a wire of area of cross-section of 1 $\mathrm{mm}^2$ in a lift going up with an acceleration of $2 \mathrm{~ms}^{-2}$. If the speed of the transverse wave on the wire is $120 \mathrm{~ms}^{-1}$, the density of the material of the wire is
(Acceleration due to gravity $=10 \mathrm{~ms}^{-2}$)

AP EAMCET 2017 Medium
A particle executing simple harmonic motion has a maximum speed of $40 \mathrm{~ms}^{-1}$ and maximum acceleration of $60 \mathrm{~ms}^{-2}$. The period of oscillation is

AP EAMCET 2021 Medium
Two blocks of masses $1 \mathrm{~kg}$ and $2 \mathrm{~kg}$ are connected by a metal wire going over a smooth pulley as shown in figure. The breaking stress of the metal is $2 \times 10^9 \mathrm{~N} / \mathrm{m}^2$. What should be the minimum radius of the wire used if it is not to break ? Take $g=10$ $\mathrm{m} / \mathrm{s}^2$

AP EAMCET 2006 Medium
When will a body of mass $20 kg$ moving at $15 m s^{- 1},$ subjected to a retarding force of $100 N$ , come to rest?

AP EAMCET 2020 Easy

Explore more questions on app

From AP EAMCET

If the lines $3 x+4 y-5=0,2 x+3 y-4=0$ and $p x+4 y-6=0$ all meet at the same point, then $p$ is equal to

AP EAMCET 2020 Easy
For an isothermal and free expansion of an ideal gas, which of the following is true?
1. For an adiabatic change, heat $(q)$ is non zero.
2. For an adiabatic change, heat $(q)$ is zero.
3. For an isothermal reversible change, heat (q) is zero.
4. For an isothermal process, the temperature changes.

AP EAMCET 2020 Medium
If A. B. C are the angles of a triangle, then
$\frac{\sin A+\sin B+\sin C}{\sin ^2 \frac{A}{2}-\sin ^2 \frac{B}{2}+\sin ^2 \frac{C}{2}-1}=$

AP EAMCET 2024 Medium
On solving $\frac{d y}{d x}=\frac{x-y+3}{2 x-2 y+5}$, the solution obtained is $x=2(x-y)+\log (t)+c$, find $t$

AP EAMCET 2020 Medium
\[
\int e^x\left(\frac{2+\sin 2 x}{1+\cos 2 x}\right) d x=
\]

AP EAMCET 2023 Easy
An infinite non-conducting sheet has a surface charge density of $7 \times 10^{-7} \mathrm{C} \mathrm{m}^{-2}$ on one side. The distance between equipotential surfaces whose potentials differ by $19.8 \mathrm{~V}$, will be
(Take $\frac{1}{4 \pi \varepsilon_{\mathrm{o}}}=9 \times 10^9$ SI units)

AP EAMCET 2022 Hard

Explore more questions on app